Hollow Form Designs

 These are my 6 Designs:





Design 1:

Design 2:


Design 3:

Design 4:

Design 5:

Design 6:













Comments

Post a Comment

Popular posts from this blog

Summer Voxel Model

Image
For this project I made a cup of coffee with a dollar bill inside of it, because I spent most of my summer working in a coffee shop. I placed the bill inside of the mug to symbolize me drowning in my tears in order to make money :) (I did enjoy my summer, but customer service can be interesting to say the least) I also decided to make the mug transparent so that the contents within it can be more defined.
Read more

Coaster Refined

Image
  This the crushed can coaster I decided to pursue: I spent a lot of time on the top off the can, making sure every detail was extruded by the right amount. The planning towards this can also took up a lot of time. I didn't want to make a mistake in rhino and have to redo everything, so I decide to sketch out my design in more detail and measure out everything before I started. For the base of the can I used red plastic, and for the top I used grey paint. I decided I would paint the details on the base of the can, as laster cutting it might be more difficult.
Read more

Coaster finale

Image
This is the coaster I made:   This is the design that I was aiming for: here is the laser-cutter setup: And this is the result: Since I wanted to make the crushed can look realistic, I decided to spray paint it. before doing so, I decided to test out the colours on a spare piece of acrylic. I applied adhesive spray the acrylic first, followed by a couple layers of spray paint, then a polishing spray to create a better finish. Once I was satisfied, I spray painted my coaster. This is the final result: I am relatively satisfied with the results produced by the laser cutter. However, I was hoping for more depth when it came to engraving details. This would have made the cracks and curves of the can more noticeable. I also found that these crevices disappeared even more after a couple layers of spray paint. If I could go back and change something about this process, I would choose not to use the polish. Overall, I think that using it did the most damage to my details and...
Read more